Table cells.

Hello to all my good friends out there.

I have created a table with a size of 3.6cm high by 20cm wide. The table
itself is 4 cells by 4 cells.
If I decide to play about with the size of the individual cells making them
higher, wider or shorter etc but then decide that I want them equally
distributed in width and/or height again, is there easy way to do this. I
cannot seem to do this without having to recreate a new table. The overall
table size obviously must stay the same.

Your help is and always has been very much appreciated.
thanking you in anticipation.
<-><-><-><->
Big Rick

Mary
Wed May 07 04:10:56 CDT 2008

Unlike Word you cannot specify the size of a cell. Use ruler guides or perhaps
grid guides to layout your page and resize the cells manually.

--
Mary Sauer MSFT MVP
http://office.microsoft.com/
http://msauer.mvps.org/
news://msnews.microsoft.com

"Big Rick" <BigRick@discussions.microsoft.com> wrote in message
news:1E5C285F-61FD-474E-8691-09579289AC04@microsoft.com...
> Hello to all my good friends out there.
>
> I have created a table with a size of 3.6cm high by 20cm wide. The table
> itself is 4 cells by 4 cells.
> If I decide to play about with the size of the individual cells making them
> higher, wider or shorter etc but then decide that I want them equally
> distributed in width and/or height again, is there easy way to do this. I
> cannot seem to do this without having to recreate a new table. The overall
> table size obviously must stay the same.
>
> Your help is and always has been very much appreciated.
> thanking you in anticipation.
> <-><-><-><->
> Big Rick

BigRick
Wed May 07 19:25:00 CDT 2008

Hello Mary. I thought it might be you that replied.

I really did try to do this and ended up getting nowhere!

Hope you are well.
Many Thanks
<-><-><-><->
Big Rick


"Mary Sauer" wrote:

> Unlike Word you cannot specify the size of a cell. Use ruler guides or perhaps
> grid guides to layout your page and resize the cells manually.
>
> --
> Mary Sauer MSFT MVP
> http://office.microsoft.com/
> http://msauer.mvps.org/
> news://msnews.microsoft.com
>
> "Big Rick" <BigRick@discussions.microsoft.com> wrote in message
> news:1E5C285F-61FD-474E-8691-09579289AC04@microsoft.com...
> > Hello to all my good friends out there.
> >
> > I have created a table with a size of 3.6cm high by 20cm wide. The table
> > itself is 4 cells by 4 cells.
> > If I decide to play about with the size of the individual cells making them
> > higher, wider or shorter etc but then decide that I want them equally
> > distributed in width and/or height again, is there easy way to do this. I
> > cannot seem to do this without having to recreate a new table. The overall
> > table size obviously must stay the same.
> >
> > Your help is and always has been very much appreciated.
> > thanking you in anticipation.
> > <-><-><-><->
> > Big Rick
>
>
>