Peter
Fri Jun 10 09:57:53 CDT 2005
I'd hope we can get one out before RTM, but as we are coding against betas
there's a chance that things will change in the run up to RTM so we will be
following a moving target. A short-term approach may be to install just the
dlls for VS2005 and leave out some of the deeper integration, we'll just
have to see how it goes...
Peter
--
Peter Foot
Windows Embedded MVP
www.inthehand.com | www.peterfoot.net | www.opennetcf.org
"Jared Miniman" <post@tothenewsgroup.thx> wrote in message
news:ugS8EVcbFHA.2180@TK2MSFTNGP12.phx.gbl...
> Peter,
>
> I assume we will not see a "proper" SDF installer for VS 2005 until 2005
> goes RTM? Perhaps later?
>
> --
> _________________________________
> Jared Miniman
> Accenture Mobile Solutions Group
>
>
> "Peter Foot [MVP]" <feedback@nospam-inthehand.com> wrote in message
> news:O9P8WHUbFHA.3120@TK2MSFTNGP12.phx.gbl...
>> The v1.3 assemblies should work fine within a v2.0 project, the
>> references will be handled by the runtime, there are a couple of
>> behavioural differences between the v1 and v2 runtimes to fix bugs which
>> existed in v1 (e.g. GCHandle offsets) but most if not all of the code in
>> v1.3 has been written to compensate for this so it will check whether it
>> needs to manually add 4 bytes.
>> At this stage the installer for v1.3 is tightly tied to VS2003, so theres
>> not easy way to utilise it from a v2.0 project - you can either grab the
>> source yourself or pull the dlls off of another machine with v1.3 already
>> installed.
>>
>> Peter
>>
>> --
>> Peter Foot
>> Windows Embedded MVP
>> www.inthehand.com | www.peterfoot.net | www.opennetcf.org
>>
>> "Jared Miniman" <post@tothenewsgroup.thx> wrote in message
>> news:%23shlBnRbFHA.3132@TK2MSFTNGP09.phx.gbl...
>>> As a follow-up, I just did ILDASM on the OpenNETCF v1.2 assemblies we're
>>> utilizing, and sure enough, it's linking to the v1.0 of things like
>>> mscorlib, System.Drawing, and System.Windows.Forms. So is everyone
>>> porting to CF 2.0 (without taking each OpenNETCF assembly's source code,
>>> converting to VS 2005, and rebuilding) out of luck?
>>>
>>> --
>>> _________________________________
>>> Jared Miniman
>>> Accenture Mobile Solutions Group
>>>
>>> "Jared Miniman" <post@tothenewsgroup.thx> wrote in message
>>> news:OAWgWKRbFHA.2288@TK2MSFTNGP14.phx.gbl...
>>>> Hi. :)
>>>>
>>>> I have a bunch of OpenNETCF 1.2 assemblies referenced in a CF 2.0
>>>> project; VS 2005 seems to want to push the *CF 1.0 CAB* file to the
>>>> device each time I deploy--could the OpenNETCF 1.2 assemblies perhaps
>>>> be causing this behavior? Is this an issue fixed with SDF v1.3?
>>>>
>>>> --
>>>> _________________________________
>>>> Jared Miniman
>>>> Accenture Mobile Solutions Group
>>>>
>>>>
>>>>
>>>
>>>
>>
>>
>
>